Adding wiring to your products

In addition to CNC machining for cassettes, we can also install wiring.

Cabling approach

The ends of the sleeves in which the test probe is located are connected to a cable. If desired, we can wire it to somewhere else.
We can do this by using the wire wrapping technique. This is a technique whereby a wire is wound around the end of a special sleeve by using a rotary gun or a solder joint.
Cabling is possible with either single-sided wiring, in preparation for the final wiring, or as a complete wiring to the Mass interconnect blocks or test electronics.

Like to know more about adding wiring to your products? We would be happy to tell you more.